Steps
1. Place the heat sink on the processor.
2. Tighten the four captive screws that secure the heat-sink to the system board, as per the callout on the system board.
NOTE:
Tighten the screws in a sequential order (1,2,3,4) as mentioned on the system board.
3. Connect the heat sink fan cable to the system board.
Next steps
1. Install the
hard-disk drive and optical-disk drive module
2. Install the
front
bezel.
3. Install the
side
cover.
4. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the
Side
cover.
3. Remove the
Front
bezel.
4. Remove the
Expansion card
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the removal procedure.
after working inside your
before working inside your
(optional if installed)
computer.
computer.
Disassembly and reassembly
37