Removing The Power Switch; Installing The Power Switch; Removing The Power Supply Unit - Dell D15S Service Manual

Power switch

Removing the power switch

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5 in. hard drive
5. Remove the hard-disk drive and optical-disk drive module
About this task
The following images indicate the location of the heat-sink and provide a visual representation of the removal procedure.
Steps
1. Disconnect the power switch cable from the system board.
2. Press the power switch retention tabs and pull the power switch out from the system.

Installing the power switch

Prerequisites
About this task
The following image indicates the location of the power switch and provides a visual representation of the installation procedure.
Steps
1. Slide the power switch module into the slot on the chassis until it clicks into place.
2. Connect the power switch cable to the connector on the system board.
Next steps
1. Install the hard-disk drive and optical-disk drive module
2. Install the 2.5 in. hard drive
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in
Power-supply unit
Removing the power-supply unit
Prerequisites
1. Follow the procedure in
2. Remove the Side cover
3. Remove the Front bezel
4. Remove the 2.5 in. hard drive
5. Remove the hard-disk drive and optical-disk drive module
42 Disassembly and reassembly
before working inside your
assembly.
assembly.
after working inside your
Before working inside your
assembly.
computer.
.
computer.
computer.
.