Unsatisfactory Printing - Brother HL-4200CN User Manual

Symptom
Creased paper
Slanted printing,
Incorrectly positioned
printing

Unsatisfactory Printing

5 - 11 TROUBLESHOOTING
Possible Cause
Is the paper damp?
Is the media suitable?
Are you using creased paper?
Is the paper tray properly inserted into the
printer?
Is there any paper or a foreign object
jammed in the printer?
Is the transfer roll cartridge or fuser unit
properly installed in the printer?
Are the paper guides in the paper tray set
correctly?
Is the paper guide in the multi-purpose tray
set at the correct mark?
Did you install the A5 spacer when loading
A5 paper into the paper tray?
Action
Replace the paper.
See Loading Paper on page 3-7.
Replace the media with a recommend size
and type, and confirm that your printer
driver settings are correct.
See Suitable and Unsuitable Paper Types
on page 3-1.
Push the paper tray completely back into
the printer.
Turn the power off and remove the jammed
paper or foreign object.
If you cannot remove the obstruction, turn
the printer off and contact your dealer or
Brother Customer Service. Do not attempt
to disassemble the printer.
Make sure that the transfer roll cartridge
and fuser unit are properly installed.
See Replacing the Transfer Roll Cartridge
(TR-11CL) on page 7-11.
See Replacing the Fuser unit (FP-12CL) on
page 7-14.
In the paper tray, set the side and end
guides to their correct positions.
See Load Paper in the Paper Tray on page
3-7.
See Load A5 Paper in the Paper
Tray/Changing the Paper Size from A5 on
page 3-10.
Set the paper guide in the multi-purpose
tray at the correct mark.
See Load Paper into the Multi-purpose Tray
on page 3-16.
Make sure that the A5 spacer is properly
installed next to the end guide in the paper
tray.
See Load A5 Paper in the Paper
Tray/Changing the Paper Size from A5 on
page 3-10.