Installation And Power Supply Facility; Installation Site; Power Supply And Connecting Cable - Panasonic YC-500WX Operating Instructions Manual

4 INSTALLATION AND POWER SUPPLY FACILITY

When installing or transporting the cutting machine, wear long sleeve shirts, leather gloves and
safety shoes to prevent injury.

4.1 INSTALLATION SITE

(1) Locate indoors only, where the floor is capable of
supporting
the weight of the product.
(2) Avoid exposure to the direct sun light or the rain or
water
spray.
<Note>
If exposed to the rain or water spray, or dew
condensation
occurred, dry the product before using it.
(3) Ambient temperature
(a) During welding operation: -10 ° C to 40 ° C
(b) During transportation/storage: -20 ° C to 55 ° C
(4) Humidity relative to temperature
(a) Up to 50 % at 40 ° C.
(b) Up to 90 % at 20 ° C.
(5) Altitude above sea level: Up to 1 000 m.
(6) Inclination to installation surface: Max. 10 °
(7) Do not block cooling air intake of the welding power
source
• From the wall: 200 mm or more.
(8) Avoid wind to the arc. (Provide windshields.)
(9) Free from abnormal amounts of dust, acid,
corrosive gases
a、 or substances
Note:
•
When the product is installed on the floor where it is too low to operate, customers are required to prepare a table to mount
the product on.
•
Such table should be provided with flanges on the mounting surface to prevent the product to slide off the table.

4.2 POWER SUPPLY AND CONNECTING CABLE

●Do not use this product in a vertical position
●Using it in the vertical position may reduce its cooling effect, and cause
any troubles like equipment burnout, etc.Therefore, make sure to use it in
the horizontal position (in the proper position).
●When transporting it, there is no problem if the lateral face with rubber
feet becomes the bottom face.
3