6 CONNECTIONS
6.1 TIG WELDING
Torch switch
receptacle
Output terminal
Base metal side
Remote
controller
receptacle
Gas outlet
NOTE: · Install the cooling water unit on the top panel of welder according to the instruction
manual of the cooling water unit.
This welder is operable without armeotecontroller.Incase of theuse,connect it
to the receptacle for the remote controller(Option).Then the control of welding and crater current
adjustments is automatically switched over to the remote controller side. While the remote
controller is set in, it is not possible to control welding or crater current adjustment from the welder.
Water outlet
Output terminal
TIG tarch side
TIG tarch
cable
Base metal
8
Distribution
box
Cooling
water unit
Water inlet
Gas inlet
Gas hose