Table of Contents
Advertisement
10.2 JIG TERMINAL AND EXAMPLE OF ITS USAGE
Remove the top panel of the welder to access to the JIG terminal board with 6 terminals in the back left side.
It is provided for user's convenience in case of using jigs together with the welder. Use any function if
necessary.
A,B· · · · · · · · · Emergency stop signal terminal
*
The welder will not operate if the short circuit line of *A,B are disconnected.
Use this when it is desired to stop the welder from the outside.
C,D· · · · · · · · · Current detecting signal terminal
*
A contact point which closes at the time of detecting the current is provided in*C,D.
(Contact point rating)
E, F ... ... ... Pulse detecting signal terminal (actuates only at LOW pulse).
*
A normal open contact point which closes at the timer of *E,F pulse current.
(Contact point rating)
AC 125V ,0.5A / DC 30V, 2A
DC 30V, 2A
AC 125V,0.4A /
20
Hide quick links:
Advertisement
Table of Contents
