1.1.5
Configuring the starter kit
After the USB driver installation is completed, configure the Mode switches on the starter kit, and
then connect it to the PC.
If the starter kit and the PC are connected by USB (i.e., power is being supplied), disconnect the
USB temporarily to turn the power OFF. Next, set the starter kit "MODE" selector to "PROG", as
shown in "Figure 1-21 MODE selection".
MODE Selector
PROG
RUN
Make sure that the MODE selector is set to "PROG".
Then, connect it to the PC.
Figure 1-21 MODE selection
Operation mode
Flash memory serial write mode:
→Used to write a program into the microcontroller.
Single chip mode:
→Used to run the program written into it.
33
AN07-00200-03E
Set the MODE selector to
"PROG".