Running The Debugger; Figure 2-34 Setting Break Points - Fujitsu F2MC-8FX Series User Manual

2.2.4

Running the debugger

As shown in "Figure 2-34 Setting break points", you can set break points to where green round mark
is located which is shown on the left side of lines in the source file. .A maximum of only two break
points can be set.
Note that you cannot set break points while the program is running.
attempting to set the third point, an error occurs.
Click this to set a break point.
To cancel the break point, click this again.

Figure 2-34 Setting break points

57
AN07-00200-03E