Table of Contents
Advertisement
INSTALLATION
3.7
JOINING THE CASES
5. Apply either black or white silicon (depending on
the interior colour of the case) all the way along
the top of the join, between the endframes of the
cases, only.
6. Finish the silicon neatly.
Seal along this edge only when cases are
joined together
PAGE 22
DOOR HANDLES
Depending on door type, door handles will be
factory fitted, but some may become loose during
transportation of the case.
Check handles and tighten if necessary.
Canopy Joining Point
FIGURE 3U
FIGURE 3W - Door Handles Are Secure
3.8
(This should be done after final Installation of
Refrigeration and Drainage connections)
•
•
FIGURE 3V
ATTACHING KICK PLATES
Use hex screws 6.3 x 19mm to fix the kickplate
support to the base. (These parts are in the
accessories box).
Do NOT fix the kickplate support to the base too
tightly. It should be able to slip up and down
through the oblong hole. This will enable the
kickplate to be moveable and it will naturally sit
correctly in relation to the floor.
SMED SEMI VERTICAL - HUSSMANN
Bentcam Door
Advertisement
Table of Contents
