Table of Contents
Advertisement
PRE INSTALLATION
2.2
OPERATING ENVIRONMENT
Cases have been factory tested to AS1731, +25
60% RH, and cross draft of maximum 0.2m/s. For
best performance, we recommend maintaining store
temperature below +24
To avoid condensation build-up, cases should be
positioned to allow air to freely circulate around the
underside and rear of the case
must be level.
Open refrigerated cases are sensitive to excessive air
disturbances. Air currents passing around cases will
seriously impair their operation. Do NOT allow air
conditioning, electric fans, open doors or windows, etc
to create air currents around the cases.
Place the case away from any heat sources as the heat
radiation and heat currents will impair the performance.
The exterior of these cases provide space for air
circulation. However, If the store conditions are outside
the recommended limits, a fan ventilation kit can be
requested.
2.3
HANDLING AND TRANSPORTING CASES
Case dimensions and case weight can be found on the
rating plate. Also refer to the latest Product Engineering
Data (PED) available from Hussmann Customer Service.
Always ensure that the moving device is of a suitable
type, and has sufficient lifting capacity for the case
weight and dimension. Always lift cases from the
underside.
NOTE: These cabinets are heavy, can
have high centres-of-gravity (thus
'tippy'), use appropriate PPE and tools
and manpower levels.
PAGE 9
C at 50% RH.
o
(refer page 7).
Cases
C at
It is the responsibility of the transport company to
o
insure adequate loading strategies are implemented to
insure the safe transportation of the Hussmann cases.
Cases should be strapped using the indicated strapping
points highlighted on the case packaging with the "strap
here" stickers' . Cases should be strapped in position
ready for transport with the appropriate rated strapping
and strap corner protector. Cases need to be secured
correctly during road transport to insure damage free
delivery. In Australia, cases should not be transported
without the strap corner protectors to insure that the tie
down web straps used from cutting into packaging and
or causing damage to case panels in transport.
The strap corner protector is a case transport
requirement in Australia, and disregarding using the
protector may cause transport damage. Without
the necessary implementation of correct strapping
protection Warehouse Managers may refuse loading.
Transportation requirements are to ensure case
integrity and prevent unnecessary damage and avoid
delays in the case installation schedule.
Strap Piece
FIGURE 2B
NOTE:
For demonstration watch:
https://www.youtube.com/
watch?v=C5wPzfFSc8Q
SMED SEMI VERTICAL - HUSSMANN
Advertisement
Table of Contents
