Table of Contents
Advertisement
GENERAL INFORMATION
NOTE:
before lifting to ensure no damage to
electrical, drain box or other extrusions
occurs.
Check underside of case
FIGURE 1A
1.6
CASE VENTILATION:
AIR FLOW:
Sources of heat or air
flow external to the
cabinet
should
be
avoided. i.e ventilation
ducts, open doors and
direct sunlight. This will
deter external air from
disrupting the air flow
from the cabinet thus
will help to maintain its
performance.
FIGURE 1B
PAGE 7
Check underside of case
LOCATION:
The refrigeration case should be positioned in a manner
that optimal air flow can flow through the underside
and rear. This will minimise the risk of condensation on
the back and/or underside. Leave 100mm gap between
the rear of the case and the back wall.
100mm
STOCKING SHELVES:
When stocking the shelves, be sure to leave a 25mm
gap in between the stock and shelf to ensure even and
consistant airflow. Not doing this correctly may result
in a blockage of airflow which could freeze the stock at
the rear, and not enough refrigeration being produced
toward the front of the case.
NO OBJECTS ON CASE:
place objects, stack or use the top of
the case as storage. Object may fall
and cause injury to personnel and /or
damage to the case.
SMED SEMI VERTICAL - HUSSMANN
25mm
25mm
25mm
FIGURE 1C
Do not
Advertisement
Table of Contents
