NEC UNIVERGE DT920 Series User Manual page 34

TO SET SCREEN SAVER
The procedure below shows how to set the Screen Saver. Screen
Saver works after the telephone in an idle state for a certain period
of time.
1.
Press Menu key while terminal is in an idle state.
□
2.
Select 1 User Settings.
□
3.
Select 3 Display.
□
4.
Select 3 Screen Saver.
□
5.
Select 1 Screen Saver Mode.
□
6.
either
Select 1 Disable or
■Default setting is
■The enabled item is highlighted.
7.
The display goes back to the Screen Saver screen.
□
When 2 Enable is selected on 6, Select
Wait Time.
Input Wait Time to launch the screen saver (1-999min)
and then press Enter key or the OK soft key.
Default value is 120 min.
If the same screen is displayed for a long time, There are
cases where LCD burning occur.
To prevent it, recommend you to enable screen saver.
□
2 Enable.
□
1 Disable.
TO ENABLE/DISABLE BACKLIGHT
The following explains how to enable/disable the backlight of LCD.
The backlight illuminates (for approximately 10 seconds) when
you press any key or lifts the handset.
1.
Press Menu key while terminal is in an idle state.
□
2.
Select 1 User Settings.
□
3.
Select 3 Display.
□
4.
Select 4 Back Light.
5.
Select desired setting from the following list.
No. Menu Item
1 Disable
2 Enable
The enabled item is highlighted.
□
2
34
TERMINAL SETUP
Meaning
Backlights of LCD is disabled.
Backlights of LCD is enabled (default).