Toshiba e-STUDIO 407CS Series Printing Manual page 149

4.PRINTING FROM UNIX/Linux
 Department Code
The department code can be set using the following option.
Option Value Alternate Value
dept=code
A department code is specified within 63 characters.
If the entered department code is longer than 63 characters, it is clipped to 63 characters when a job is sent.
The following characters are invalid for department codes:
" & ' ( ) ; < > ^ ` | ~ @ # % * !
 How the equipment performs printing for an invalid department code print job, for which an invalid department code
is specified, varies depending on the Invalid Department Code Print Job setting that can be set in the TopAccess
Administrator mode and whether SNMP communication is enabled or not.
- When SNMP communication is enabled and Invalid Department Code Print Job is set to [Store to invalid job
list], an error message will be displayed when an invalid department code is entered.
- When SNMP communication is disabled and Invalid Department Code Print Job is set to [Store to invalid job
list], the invalid department code print job will be stored in the invalid department code print job list without
printing.
- When the Invalid Department Code Print Job is set to [Print], the invalid department code print job will be
printed.
- When the Invalid Department Code Print Job is set to [Delete], the invalid department code print job will be
deleted.
 For the appropriate department code, ask your system administrator.
 Distinguish Thin Lines
This sets whether to distinguish thin lines or not. This mode can be set using the following option.
Option Value Alternate Value
thinlinelimit=on ON
thinlinelimit=off OFF
Example: The command to set the thin line limit mode is "lp -o thinlinelimit=on <filename>".
 Do Not Print Blank Pages
This sets whether or not a blank page is printed. This mode can be selected using the following option.
Option Value Alternate Value
blankpage=0
blankpage=1
Example: The command to set the blank page mode is "lp -o blankpage=0 <filename>".
 Toner Save
The toner save mode can be set using the following option.
Option Value Alternate Value
tonersave=on ON
tonersave=off OFF
Example: The command to set the toner save mode is "lp -o tonersave=on <filename>".
Description
Set the department code. A department code within 63
characters comes in [code].
Description
Set the thin line limit mode.
Cancel the thin line limit mode.
Description
Set the blank page mode (disable Do not Print Blank
Pages).
Cancel the blank page mode (enable Do not Print Blank
Pages).
Description
Set the toner save mode.
Cancel the toner save mode.
4 PRINTING FROM UNIX/Linux
Printing From Application 147