Stick Welding - Panasonic YC-300BZ3YHD Operating Instructions Manual

Configuration

4.2 Stick welding


Customers are required to prepare the items other than
marked as "This product" or "Accessory".

The items marked with "*" are available as peripheral
equipment (optional items), with separate sales. (See
section "Peripheral equipment").
Note
(1) Fingertip joint
Make sure to use the Panasonic genuine products
only. Or the connection part may be burnt due to poor
contact.
(2) Base metal cable
To prevent overheat of the cable and provide with
proper welding, prepare a cable which is a welding
cable or cabtire cable (excluding the class-1 cabtire cable
and vinyl cabtire cable) of 38mm2 or more
(3) The polarity between the electrode holder ((13)) and
the base material shown in the above figure is elec-
trode positive (DCEP), as normally applied to stick
welding. (Depending on the types of work, it is required
to change the polarity.)
No.
1 Welding power source
2 Distribution box
3 Input power cable
4 Grounding wire
5 Fingertip joint
*1
6
Fingertip joint
*1
Prepare the fingertip joint (CWC00180) to connect to the cable from the electrode holder.
*2
Connect it to the output cable of the base metal if necessary.
Notice
About stick welding

In case of stick welding operatin, please check ans operate in the follwoing order.
(1) Refer to section "9.3 STICK welding operation" on page 42.
(2) When using the remote controller (See section 4.3.6 on page 18), and connect the remote controller before performing
the following procedure.
(3) Select "STICK" using the "MODE" button (See section 5.1 on page 19).
(In case that the "STICK" has already been selected before connecting the remote controller, turn off the power and con-
nect the remote controller, and then turn the power back on again.)

Once "STICK" is selected, you can only change modes or adjust welding current.
It is not possible to execute TIG/SPOT welding related settings as they are unrelated to the stick welding.

In case of having a remote controller been connected, welding current can only be adjusted by the "Welding cur. Adj."
volume of the remote controller.
Jog dial (See section 5.1 on page 19) operation is not valid. Volumes or switches other than "Welding cur. Adj." on the
remote controller are not valid.
12
Item Remarks
This product
Accessory
6
9
11
4
No.
7 Electrode holder
8 Welding electrode
9 Remote controller
10 Base metal
11
Base metal cable
*
2
1
3
4
5
7
10
8
Item Remarks
*2
OMCTT5621E18
*