Mounting - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 3 | Central Control Equipment
The protocol as well as the baudrate settings for both
RS232 ports are set with the S500 dip switches inside
the CCU (see table 8.5 and table 8.6).
table 8.5: RS232 protocol settings (* = default)
Protocol
Open interface
Terminal
Full
Reserved
table 8.6: RS232 baudrate settings (* = default)
Baudrate
9.6k
19.2k
57.6k
115.2k
Note
It is possible to select 'Full' protocol on both
port 1 and 2. However, this is not recommended
due to processing power and memory
limitations
8.4

Mounting

The CCU is suitable for either table-top or 19-inch rack
mounted use. Four feet (for table-top use) and two
mounting brackets (for rack mounting) are supplied.
The mounting brackets can also be used to mount the
CCU to a flat surface.
figure 8. 1 3: Mounting
Bosch Security Systems | 2004-03 | 9922 141 70521en
Port 1
Switch S500-1 Switch S500-2
Off Off
Off On
On* Off*
On On
Port 1
Switch S500-3 Switch S500-4
Off Off
Off On
On Off
On* On*
Port 2
Switch S500-5 Switch S500-6
Off Off
Off On
On Off
On* On*
Port 2
Switch S500-7 Switch S500-8
Off Off
Off* On*
On Off
On On
en | 68