Connecting The Mouse Receiver - Sharp XG-V10XE Operation Manual

Connecting the Mouse Receiver

Connecting the Remote Mouse Receiver
You can use the remote control as a remote mouse to operate computers
compatible with PS/2 or USB type mouse systems.
Connecting to the USB port on a PC or Macintosh
1 Connect one end of the supplied USB mouse control cable to the corresponding terminal on the computer.
2 Connect the other end to the USB port on the remote mouse receiver.
Connecting to the PS/2 port on a PC
1 Turn off the power of the PC.
2 Connect one end of the supplied PS/2 mouse control cable to the corresponding terminal on the PC.
3 Connect the other end to the PS/2 port on the remote mouse receiver.
4 Turn on the power of the PC.
CAUTION
• Do not connect or disconnect the mouse control cables to or from the computer while it is on.
This may damage your computer.
• Do not connect both the PS/2 and USB mouse control cables to the remote mouse receiver.
• Windows 95 does not support USB mouse driver software.
• The minimum system requirements for the USB type mouse system are shown below.
Windows
Hardware: PC/AT compatible machine with USB port that has Windows 98/Windows NT 5.0 or
higher installed.
OS: Windows 98/Windows NT 5.0 or higher
Macintosh
Hardware: Macintosh series with USB port
OS: Mac OS 8.5 or higher
USB mouse control
cable
PS/2 mouse control
cable
Remote mouse
receiver
Use the USB port
(PC or Macintosh) to
connect the supplied
USB mouse control
USB port
cable to the remote
mouse receiver.
Remote mouse
receiver
Use the PS/2 port
(PC) to connect the
supplied PS/2 mouse
control cable to the
PS/2 port
remote mouse
receiver.
1.2.3 4.5.6
Conference Series
38