Table of Contents
Advertisement
Setting the
Projector
(GUI) On-screen Display
Replacing the Lamp
CAUTION
• Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest
Sharp Authorised LCD Projector Dealer or Service Centre for a replacement.
• Do not remove the lamp cage directly after operation of the projector. The lamp may be extremely
hot. Wait at least one hour after the power cord is disconnected to allow the surface of the lamp cage
to fully cool before removing the lamp cage.
It is recommended that the lamp be replaced after approximately 900 cumulative hours of use or when you notice
a significant deterioration of the picture and colour quality. Carefully change the lamp by following the steps on the
next page.
If the new lamp does not light after replacement, take your projector to the nearest Sharp Authorised LCD Projector
Dealer or Service Centre for repair. Purchase a replacement lamp unit (lamp/cage module) of the current type
BQC-XGV10WU/1 from your nearest Sharp Authorised LCD Projector Dealer or Service Centre. Then carefully
change the lamp by following the instructions on the next page. If you wish, you may have the lamp replaced at
your nearest Sharp Authorised LCD Projector Dealer or Service Centre.
71
Lamp Mode
Remote Control
1, 6
2, 3, 4
5
1.2.3
4.5.6
This function can be used to set the lamp mode.
The mode can be set to double the effective lamp usage
time.
Description of Lamp Mode
Selected item
Description
Both Lamps
Both lamps are used for greater brightness.
Lamp 1 is used.
Lamp 1 Only
When lamp 1 burns out, automatically
switches to lamp 2.
Lamp 2 is used.
Lamp 2 Only
When lamp 2 burns out, automatically
switches to lamp 1.
Both lamps are used alternatingly.
Equal Use
Switches after every 100 hrs. of use.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Options (2)".
3 Press ∂/ƒ to select "Lamp Mode", and then
press ©.
4 Press ∂/ƒ to select the desired Lamp Mode.
5 Press ENTER to save the setting.
6 To exit from the GUI, press MENU.
• In "Equal Use" mode, when the projector is used for more than
24 hrs. continuously, it switches in shift of 100 hrs.
MOUSE
ADJ.
Advertisement
Table of Contents
