Table of Contents
Advertisement
Lamp Maintenance
Confirming the Lamp Usage Time
Lamp
The lamp in this projector operates for approximately 1,000 cumulative hours, depending on the usage environ-
ment. (As the usage environment can vary significantly, the projector lamp may not operate for 1,000 hours.) It is
recommended that the lamp be replaced after approximately 900 cumulative hours of use or when you notice a
significant deterioration of the picture and colour quality. The lamp usage time can be checked with the On-screen
Display.
CAUTION
• Intense light hazard. Do not attempt to look into the aperture and lens while the projector is operating.
Projector
1, 4
2, 3
(GUI) On-screen Display
Condition
The LAMP REPLACEMENT
indicator lights up red, and "LAMP"
and " " will flash in yellow in the
lower-left corner of the picture.
A significant deterioration of the
picture and colour quality occurs.
The power will automatically turn
off and the projector will enter
standby mode.
"LAMP" and " " will flash in red in
the lower-left corner of the picture,
and the power will turn off.
This function allows you to check the accumulated lamp
Remote Control
usage time.
1.2.3
4.5.6
• It is recommended that the lamp be replaced after
Problem
• Lamp has been used for over 900
hours.
• Lamp has been used for over 1,000
hours.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Options (2)".
3 Press ∂/ƒ to select "Lamp Timer". The lamp
usage time will be displayed.
4 To exit from the GUI, press MENU.
approximately 900 cumulative hours of use. See pages 71
and 72 for lamp replacement.
• Purchase a replacement lamp unit
(lamp/cage module) of the current
type BQC-XGV10WU/1 from your
nearest Sharp Authorised LCD
Projector Dealer or Service Centre.
• Replace the lamp. (See pages 71
and 72.) If you wish, you may have
the lamp replaced at your nearest
Sharp Authorised LCD Projector
Dealer or Service Centre.
MOUSE
ADJ.
Possible Solution
70
Advertisement
Table of Contents
