Panasonic PT-AH1000E Operating Instructions Manual page 47

■ [MOTION EFFECT]
Videos with a lot of movement can also be viewed sharply.
Switch settings
[OFF]
MOTION EFFECT inactive
[ON]
MOTION EFFECT active
Note
The effect on the video may be difficult to see in some
z
cases.
■ [COLOUR MANAGEMENT]
For the selected [PICTURE MODE], you can adjust a
selected color individually with [CURSOR] mode or adjust
the six color components (Red, Green, Blue, Cyan,
Magenta, Yellow) with [RGBCMY] mode.
Adjustment results can be saved as a profile and called
later.
●Create a new profile
Note
[COLOUR MANAGEMENT] will be unable to adjust with
z
the setting of [REC709] in [PICTURE MODE], when
HDMI signal is selected.
When the input signal is switched while adjusting,
z
adjustment details are not saved.
If there is another area, which has the exact same or
z
similar color as the target on the same screen, these
colors will be adjusted as well.
You can adjust all colors except white, gray and black.
z
If you edit a single color to be individual different colors,
z
the desired color may not be achieved.
Switch settings
Note
z
z
z
[PICTURE] menu
Adjusting the selected color (when
z
[CURSOR] is selected for [ADJUSTMENT
MODE])
Select the desired color with a cursor and adjust.
1) Press the ◄► buttons to select [CURSOR]
in [ADJUSTMENT MODE].
COLOUR MANAGEMENT
PROFILE NORMAL
ADJUSTMENT MODE CURSOR
START ADJUSTMENT
LOG
2) Press the ▲▼ buttons to select [START
ADJUSTMENT] and press the <ENTER>
button.
The cross cursor (A) is displayed, and the
z
projected image is captured.
Screen
3) Move the cursor with the ▲▼◄► buttons
to the required place to select a color.
Align the center of the cross cursor on the point
z
in the projected image to be adjusted.
4) Press the <ENTER> button.
[CURSOR] menu (B) and the color selected (C)
z
are displayed.
CURSOR
COLOUR
DEFAULT
ENTER
TINT
SELECT
BRIGHTNESS
RETURN
Screen
In some cases you may be unable to adjust when the
very edge point of the projection area is selected.
You can create a profile only when [ADJUSTMENT
MODE] is set to either [CURSOR] or [RGBCMY]. A profile
cannot be created from both adjustments.
White, gray and black cannot be edited.
0
0
0
ENGLISH - 47