Table of Contents
Advertisement
2
Move the cursor over the clip that contains the text memo to be played back and press the control stick.
The cursor moves to the lower section of the LCD monitor. (Fig. 2)
3
With the cursor located in the lower section, press the control stick to the left/right to move the cursor to the text memo number
you want to play back and press the <=/&> button.
f Playback starts from the time code position of the text memo where the cursor is located.
If the <(> button is pressed during playback or the playback has finished at the end of the clip, the thumbnail screen appears again and the cursor
returns to the thumbnail of the text memo where the playback started.
f While holding down the <SHIFT> button, press the control stick upward/downward to move the cursor to the first/last text memo.
f Press the <EXIT> button to return the cursor to the upper section of the thumbnail screen.
@
NOTE
t Pressing the REC button while the text memo screen is displayed does not start recording.
t For clips in AVC-Intra and AVC-LongG formats with different settings (different system frequencies) in the main menu → [SYSTEM MODE], the
thumbnail of the text position may not be displayed and a thumbnail image with the [!] mark may be displayed.
Deleting text memos
1
Perform steps 1 to 2 in "Playing back from the text memo position" (page 103) to select the desired text memo in a clip.
2
Move the cursor over the text memo to be deleted and press the control stick.
3
Select [DELETE] in the main menu → [CLIP] and press the control stick.
4
Select [YES] using the control stick.
This deletes the text memo.
Using a text memo to divide a clip and copy the necessary portion
1
Perform steps 1 to 2 in "Playing back from the text memo position" (page 103) to select the desired text memo in a clip.
2
Move the cursor over the text memo to be copied and press the control stick.
You can select multiple text memos.
3
Select [COPY] in the main menu → [CLIP].
4
Select the copy target slot using the control stick and select [YES].
f Copying starts.
f The portion between the selected text memo and the next one is copied. If no text memo is found after the selected one, then the part after the
selected text memo to the end of the clip is copied.
f If multiple text memos are selected, the selected sections are copied.
f While the clip is being copied, the progress of the copy process and cancelation will be displayed. To discontinue the copy process, press the
control stick. When the [YES]/[NO] confirmation screen is displayed, use the control stick to select [YES].
NOTE
@
t In clip division and copying using the text memo, the area copied may be automatically modified and copied depending on the recording method of the
clip.
Deleting clips
1
Use the control stick to move the cursor over the clip to be deleted, and press the control stick to select the clip.
2
Select [DELETE] in the main menu → [CLIP] and press the control stick.
3
Select [YES] using the control stick.
The clip is deleted. All selected clips (in blue-green frames) are deleted by this operation.
@
NOTE
t To interrupt the deletion process, press the <SHIFT> button + <EXIT> button or press the control stick to cancel the operation. Once a clip is deleted
halfway, it cannot be restored even if the deletion process is aborted.
Restoring clips
You can restore clips that were made defective as a result of sudden power-down during recording or removal of the P2 card being accessed.
1
Use the control stick to move the cursor over the clip to be restored (defective clips are indicated by defective clip marks) and
press the control stick to select the clip.
2
Select [REPAIR] in the main menu → [CLIP] and press the control stick.
3
Select [YES] using the control stick.
This restores the clip.
Chapter 5 Playback — Thumbnail operations
– 104 –
Advertisement
Table of Contents
