Table of Contents
Advertisement
Front side, rear side
1 Built-in microphone (page 62)
This is the built-in stereo microphone.
2 Light sensor
Detects indoor and outdoor light.
3 Front tally lamp (page 41)
Lights during shooting. This lamp will blink when the battery level becomes low.
4 Recording button (front side) (page 43)
Press this button to start recording. Press it again to stop recording.
The operation of this button can be forbidden by the main menu → [SW MODE] → [FRONT REC].
5 <AWB> button (page 50)
Press this button to adjust the white balance. Press it for two seconds or more to adjust the white balance and then black balance.
6 Eye sensor (page 40)
Bring your eyes closer to display the screen on the viewfinder.
@
NOTE
t The eye sensor may not work properly depending on the shape of glasses in use, how you hold the camera, or by hitting the strong light around
the eye piece.
t The eye sensor does not work during video playback.
7 Viewfinder (page 40)
8 <AUDIO INPUT 1> terminal (XLR, 3-pin) (page 30)
Connect the audio equipment or the microphone.
9 Rear tally lamp (page 41)
Light during shooting. This lamp will blink when the battery level becomes low.
10 Battery attachment (page 26)
11 Battery release button (page 26)
Remove the battery.
12 microP2 memory card 1 access LED (page 34)
Indicate the access status of recording and playback of the card inserted in the microP2 memory card slot 1.
13 microP2 memory card slot 1 (page 33)
14 microP2 memory card 2 access LED (page 34)
Indicate the access status of recording and playback of the card inserted in the microP2 memory card slot 2.
15 microP2 memory card slot 2 (page 33)
16 P2 memory card slot (page 33)
17 P2 memory card access LED (page 34)
Indicate the access status of recording and playback of the card inserted in the P2 memory card slot.
18 <AUDIO OUT> terminal (page 149)
Output audio signals recorded to audio channel 1/2.
19 <USB3.0 HOST> terminal (host) (page 151)
Connect external hard disk drive, etc.
20 <USB2.0 DEVICE> terminal (device) (page 151)
Connect to a computer with the USB 2.0 cable to transfer data.
21 <HDMI OUT> (monitor output) terminal (page 149)
This is the output terminal of the video for monitor.
Chapter 2 Description of Parts — Front side, rear side
1
2 3
1
4
5
12
13
14
15
6
7
16
17
9
10
11
– 20 –
8
18
19
20
21
22
23
Advertisement
Table of Contents
