Advertisement
Trouble shooting • Busqueda de fallos
Recherche de panne • Localização de erros
8
LED not lighting up
El LED no se enciende
La LED n'est pas allumée
Todos os LED's apagados
Pressing of test button,
but no condensate discharge
El interruptor de „TEST" está pulsado,
pero el condensado no se evacua
La touche Test est actionnée,
mais sans purge du condensat
Botão de teste premido, mas não há
descarga de produto de condensação
Condensate discharge only
when test button is being pressed
Evacuación del condensado soló
si está pulsado el interruptor de „TEST"
Purge du condensat uniquement
si la touche Test est actionnée
Descarga de produto de condensação
só com o botão de teste premido
Device keeps blowing off air
El aparato está abierto constantemente
L'appareil refoule de l'air en
permanence
Aparelho deixa continuamente
escapar ar
english
Possible causes:
• Power supply faulty
• Power supply board defective
- Check voltage on type plate.
- Check connections
- Check printed circuit boards for pos-
sible damage
Possible causes:
• Feed and/or outlet line shut off or blok-
ked
• Worn parts
• Power supply board defective
• Service unit defective
• Dropping below necessary minimum
pressure
• Max. pressure exceeded
- Check feed line and outlet line
- Check if valve opens audibly (press test
button several times)
- Check printed circuit board for possible
damage
- Check operating pressure
Possible causes:
• Feed line with insufficient slope; cross-
section too small.
• Excessive condensate quantities
• Service unit extremely dirty
- Lay feed line with adequate slope
- Replace service unit
Possible causes:
• Service-Unit defective or dirty
- Replace service unit
BEKOMAT 31 stand alone
Advertisement
