Table of Contents
Advertisement
Nuclias Connect Hub Plus User Manual
Your Nuclias account must be validated before use. You will receive an email from
verify@nuclias.com with a verification link included. Please click the verification link to
activate your Nuclias account.
Once finished, specify the following parameters on the Single Sign-On page, then click Login.
Enable Nuclias Single Sign-on
Nuclias Account
Nuclias Password
Note: The Single Sign-on (SSO) will be automatically disabled if the Hub is offline for more
than 30 days. You will need to enable Single Sign-on (SSO) again and log in with your Nuclias
account.
The Nuclias Connect portal provides you with an easy way to access and check the status of
all your Hub(s).
Requirements for use include:
• A Nuclias account
• DNH-200 device(s) with Single Sign-On enabled
The portal can be found at:
After logging in to the portal, you can view the following information:
Number
Status
Name
Host
Sites
Networks
Devices
Clients
Version
Actions
Check to enable Single Sign-On (SSO).
Enter your Nuclias account username.
Enter your Nuclias account password.
https://connect.nuclias.com/
Order on the list.
Displays whether the Nuclias Connect portal can
Name of the Hub.
Displays both the Hub's LAN IP address and public IP address.
Number of sites managed by the Hub.
Number of networks managed by the Hub.
Number of devices (including both AP and camera devices)
managed by the Hub: Online / Total.
Number of clients connected to AP devices managed by the
Hub.
Firmware version of the Hub.
Click Launch to open the Hub's web interface. Please note that IP
address mapping between WAN and LAN is required for
instances behind a firewall or router. Click Forget to disconnect
29
System Settings
link to the Hub.
Advertisement
Table of Contents
