Panasonic EYFLA4 Quick Manual page 7

Number
Button Setting Mode
of Push
0 Speed Setting
A
1 times Buzzer setting
1 Times LED Light
B
2 times Rundown error detecting
3 times Variable speed control
1 time Restore Factory Defaults
2 times Maintenance interval alarm
C
Out of range disable
3 times
function
1 time Cross thread reduction
D
2 times Auto Down Shift
*
A clutch adjustment tool is required for torque settings.
1. Rotate the clutch adjustment tool CW to open the tamper resistant door.
2. Flip the clutch adjustment tool over to adjust the clutch to the desired torque.
3. Rotating the clutch adjustment tool clockwise will increase torque and counter clockwise to
decrease torque.
4. Once the desired torque is set, remember to close the tamper resistant door rotating the
clutch adjustment tool CCW.
Clutch Tools
EYFG1N | EYFG2N | EYFG3N
Quick Programming guide
Tool display
80 = Full speed
15~80: 10 rpm each
b0: No buzzer
b1: Buzzer with OK
b2: Buzzer with NOK
L1: by LED button (5min)
L2: by trigger switch
0～30 = Off
1～3.0sec = .1 to 3.0sec
P0: Variable speed (ON)
P1: Single speed (OFF)
F
0～99 = Off
1-99 = 10,000-990,000
Run Downs
C0: OFF
C1: ON
R0: OFF
R1: 360°reverce (ON)
0～30 = Off
1～30 = .1 to 3.0sec
Panasonic Life Solutions Company of America Assembly Tools Division
2 Riverfront Plaza 5
www.panasonic.com/assemblytools
Description
Select stage with ＋/－button. Initial setting is 「80」
Adjustable speed in 10 rpm increments
Select stage with ＋/－button. Initial setting is 「b0」
Select stage with +/- button. Initial setting is 「L1」
Select stage with ＋/－button. Initial setting is 「0」
Select stage with ＋/－button. Initial setting is 「P0」
Speed can be controlled by use of the trigger.
All settings return to initial setting. On "F" press "Save" (Blue Button)
Select stage with ＋/－button. Initial setting is 「0」
When total fastening times are within 1 hour of preset maintenance interval, tool's display blinks
notifying the operator.
Once tool reaches the preset interval, the tool is locked out from further use.
Select stage with ＋/－button. Initial setting is 「C0」
In the event that wireless communication cannot be completed between the tool and the
qualifier, the tool will be disabled and cannot be operated.
Select stage with ＋/－button. Initial setting is「R0」
Tool first reverses 360 degree, aligning the threads, greatly reducing the possibility of cross
threads.
Select stage with ＋/－button. Initial setting is 「U」
High speed run down time starts on trigger pull then automatically downshifts to 300 rpm
th
Floor Newark, NJ 07102