Configuring Bof Parameters - Nokia 7210 Configuration Manual

Boot Options
Figure 22
4.10.3.7
See the following sections for sample output of a BOF configuration on 7210 SAS
platforms:
4.10.3.7.1
The following is a sample output of a BOF configuration for the 7210 SAS-M,
7210 SAS-T, and 7210 SAS-Mxp.
A:7210>show# bof
===============================================================================
BOF (Memory)
===============================================================================
2.0
#eth-mgmt Port Settings:
#uplinkA Port Settings:
uplinkA-autoneg
uplinkA-vlan
#uplinkB Port Settings:
uplinkB-autoneg
176
Front Panel: 7210 SAS-Sx 10/100GE 64SFP+ 4QSFP28

Configuring BOF Parameters

• Sample Output: BOF Configuration for 7210 SAS-M, 7210 SAS-T, and
7210 SAS-Mxp
• Sample Output: BOF Configuration for 7210 SAS-R6
• Sample Output: BOF Configuration for 7210 SAS-R12
• Sample Output: BOF Configuration for 7210 SAS-Sx/S 1/10GE
Sample Output: BOF Configuration for 7210 SAS-M, 7210 SAS-T, and
7210 SAS-Mxp
primary-image ftp://*:*@xxx.xxx.xxx.xx//import/panos_builds/nightly/
primary-config tftp://xx.xxx.xx.xxx/MTU/mtu3DGP.cfg
eth-mgmt-disabled
uplinkA-port 1/1/24
uplinkA-address xx.xxx.xx.xx/24
uplinkA-duplex full
uplinkA-speed 1000
0
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-duplex full
uplinkB-speed 1000
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
/S80/MTU-sultan/
3HE 17358 AAAB TQZZA
hw0744