Nokia 7210 Configuration Manual page 445

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
[no] schedule
Context config>system>cron
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the type of schedule to run, including one-time only (oneshot),
periodic or calendar-based runs. All runs are determined by month, day of month or weekday,
hour, minute and interval (seconds).
The no form of this command removes the context from the configuration.
Parameters schedule-name — Specifies the name of the schedule.
owner schedule-owner — Specifies the owner name of the schedule.
count
Syntax count number
Context config>system>cron>sched
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command configures the total number of times a CRON interval schedule is run. For
example, if the interval is set to 600 and the count is set to 4, the schedule runs 4 times at
600 second intervals.
Parameters number — Specifies the number of times the schedule is run.
day-of-month
Syntax day-of-month {day-number [..day-number] all}
[no] day-of-month
Context config>system>cron>sched
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command specifies which days of the month that the schedule will occur. Multiple days
of the month can be specified. When multiple days are configured, each of them will cause
the schedule to trigger. If a day-of-month is configured without configuring the month,
weekday, hour and minute commands, the event will not execute.
3HE 17358 AAAB TQZZA
Values 1 to 65535
Default 65535
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
445