Nokia 7210 Configuration Manual page 460

System Management
The no form of this command removes the file location from the configuration. Scripts will not
execute if there is no result location defined.
Default no results
Parameters file-url — Specifies the location to send the CLI output from script runs. The file-url is a
System Time Commands
dst-zone
Syntax [no] dst-zone [std-zone-name | non-std-zone-name]
Context config>system>time
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
460
location, directory, and filename prefix to which a data and timestamp suffix is added
when the results files are created during a script run, as follows:
file-url_YYYYMMDD-hhmmss.uuuuuu.out
where: YYYYMMDD — date
hhmmss — hours, minutes, and seconds
uuuuuu — microseconds (padded to 6 characters with leading zeros)
Values file-url — local-url | remote-url
local-url — [cflash-id/] [file-path]
remote url — [{ftp:// | tftp://}| login:password@remote-location/][file-
remote-location — [hostname | ipv4-address | ipv6-address]
cflash-id — cf1:
usb-flash-id — uf1:
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
255 chars maximum, including cflash-id
directory length 99 characters maximum each
path]
255 characters maximum
directory length 99 characters maximum each
ipv4-address — a.b.c.d
ipv6-address — x:x:x:x:x:x:x:x[-interface]
interface — 32 characters maximum, for link
local addresses
© 2021 Nokia.
Configuration Guide
x:x:x:x:x:x:d.d.d.d[-interface]
x — 0 to FFFF (hexadecimal)
d — 0 to 255 (decimal)
3HE 17358 AAAB TQZZA