Nokia 7210 Configuration Manual page 633

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Table 80
sntp
Syntax sntp
Context show>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command displays SNTP protocol configuration and state.
Output The following output is an example of SNTP information, and
output fields.
Sample Output
*A:pc-4.0# show system sntp
===============================================================================
SNTP Status
===============================================================================
Admin Status : up
===============================================================================
===============================================================================
SNTP Servers
===============================================================================
SNTP Server
-------------------------------------------------------------------------------
10.135.16.90
-------------------------------------------------------------------------------
No. of SNTP Servers: 1
===============================================================================
*A:pc-4.0#
3HE 17358 AAAB TQZZA
Output Fields: PTP Unicast (Continued)
Label
Dir
Type
Rate
Duration
State
Time
PTP Peers
Total Packet Rate
Use subject to Terms available at: www.nokia.com
Description
Displays the direction of the unicast information: either Rx or Tx
Displays the message type
Displays the rate of the unicast information, in packets per
second
Displays the lease duration for the session
Displays the state
Displays the time the unicast information was received
Displays the number of PTP peers
Displays the total packet rate, in packets per second
Oper Status : up
Version Preference
3 Preferred
© 2021 Nokia.
System Management
Table 81 describes SNTP
Mode : broadcast
Interval
64
633