Nokia 7210 Configuration Manual page 209

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
standalone-vc — The node boots up in standalone VC mode when the host-type
use-expansion-card-type
Syntax [no] use-expansion-card-type { m4-ds1-ces | m2-xfp }
Context bof
Platforms 7210 SAS-M (network mode and access-uplink mode)
Description This parameter identifies the expansion card type to the system before boot up. The system
allocates appropriate resources based on this information. The system allows only
provisioning of the MDA currently specified in the BOF. A log message is displayed if an MDA
type mismatch is detected. The system has to be rebooted if this parameter is changed.
For 7210 SAS-M devices in access-uplink mode, only the 2x10G MDA is supported.
Therefore, the value of this parameter must be set to m2-xfp.
Default m4-ds1-ces
Parameters m4-ds1-ces — Keyword to identify a 4- port T1/E1 CES MDA.
m2-xfp — Keyword to identify a 2- port 10G Ethernet MDA.
no-service-ports
Syntax [no] no-service-ports {port-id | port-id}
Context bof
Platforms 7210 SAS-M 24F 2XFP (network mode and access-uplink mode) and
7210 SAS-M 24F 2XFP ETR (network mode and access-uplink mode)
Description 7210 SAS-M 24F 2XFP and 7210 SAS-M 24F 2XFP ETR devices support only 26 Ethernet
ports when the 2x10G MDA is in use.
When the 2x10G MDA is in use, this command specifies the 26 Ethernet ports to be used,
among the total of 28 Ethernet ports available. The remaining two Ethernet ports are not used
and the service traffic received on these ports is not processed. Any of the 24x1G fixed
Ethernet ports, 2x10G fixed Ethernet ports, or 2x10G MDA Ethernet ports can be specified
by the user. Two ports as a list of two port-id tuple can also be specified.
3HE 17358 AAAB TQZZA
parameter is set to standalone-vc.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
Boot Options
209