Mitsubishi Electric HS-U449 Service Manual page 23

9. Install the units from the SLIP WASHER to the REEL
BELT shown in Fig. 2-14-1.
Note1 : Be sure to replace the removed PULLEY BUSH
with a new one.
Note2 : Attach the SLIP SPRING with its straight end
facing the SLIP GEAR side.
Note3 : Attach the SLIP WASHER in the orientation
shown in Fig. 2-14-5.
Note4 : Apply grease (PG-641) [859D055O30] to the
specified part on the SLIP WASHER in Fig. 2-14-
5.
10. Install the SHIFT SLIDER to the SHIFT LEVER shown
in Fig. 2-14-1.
Align the Lug of the
IDLER UNIT
SLIP ADJUSTER with
the Center Notch of
the IDLER UNIT.
PULLEY GEAR ASSY
[SLIP GEAR side]
Straight end
[THRUST WASHER side]
Apply grease (PG-641) to the parts marked by
- 10 -
SLIP ADJUSTER
Center of the
BELT PULLEY
Apply grease
(PG-641) to the
parts marked by
Fig. 2-14-3
Felt Side
SLIP GEAR
Grooved Side
Fig. 2-14-4
SLIP SPRING
SLIP WASHER
Fig. 2-14-5
.
.