Mitsubishi Electric HS-U449 Service Manual page 30

2-22.L/D LOCK LEVER
DECK POSITION : Normal
Remove the following parts before replacing the L/D
LOCK LEVER. Refer to the corresponding items to install
them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
• MOTOR HOLDER (Item 2-16)
• PINCH ARM CAP (Item 2-17)
• PINCH UNIT (Item 2-17)
• BRAKE CAM PLATE (Item 2-19)
(Removal)
1. Remove the L/D LOCK LEVER shown in Fig. 2-22.
(Installation)
1. Install the L/D LOCK LEVER shown in Fig. 2-22.
2-23.BRAKE BELT (SP), BELT HOLDER
DECK POSITION : Normal
Remove the following parts before replacing the BRAKE
BELT (SP) and BELT HOLDER. Refer to the
corresponding items to install them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
(Removal)
1. Lift the BRAKE BELT (SP) shown in Fig. 2-23 to
remove it from the REEL DISK (SP side).
2. Release the BRAKE BELT (SP) from the catch (a) of
the BELT LEVER shown in Fig. 2-23.
3. Release the two catches (b) of the BELT HOLDER
shown in Fig. 2-23 and separate the BELT HOLDER
from the BRAKE BELT (SP).
4. Release the catch (c) of the BELT HOLDER shown
in Fig. 2-23 to remove the BRAKE BELT (SP).
(Installation)
Note : Install the BRAKE BELT (SP) so that its felt side
touches the REEL DISK (SP side). Grease
applied to the BRAKE CAM PLATE and MAIN
PLATE ASSY shall not adhere to the felt side of
the BRAKE BELT (SP).
1. Hook the BRAKE BELT (SP) shown in Fig. 2-23 to the
catch (c) of the BELT HOLDER.
2. Install the BELT HOLDER shown in Fig. 2-23.
3. Hook the BRAKE BELT (SP) shown in Fig. 2-23 to the
catch (a) of the BELT LEVER.
4. Hook the BRAKE BELT (SP) shown in Fig. 2-23 to the
REEL DISK (SP side).
L/D LOCK LEVER
a
REEL DISK (SP side)
- 17 -
Fig. 2-22
b
BELT HOLDER
c
BRAKE BELT (SP)
BELT LEVER
Fig. 2-23