Mitsubishi Electric HS-U449 Service Manual page 35

(Installation)
1. Apply grease (MULTEMP AC-DM)[859D055O90] to
the specified parts on the MAIN PLATE ASSY in Fig.
2-30-1.
2. Apply grease (MULTEMP AC-DM)[859D055O90] to
the specified parts on the LOADING ARM ASSY (TU)
in Fig. 2-30-2.
3. Install the LOADING ARM ASSY (SP) and LOADING
ARM ASSY (TU) so that the marks on both the units
are aligned each other as shown in Fig. 2-30-3.
Note : Be sure to replace the removed LOADING ARM
ASSY (SP) with a new one.
4. Install the SPACER PLATE shown in Fig. 2-30-1.
2-31.A/L LEVER
DECK POSITION: Upside down
Remove the following parts before replacing the A/L
LEVER. Refer to the corresponding items to install them.
• STAY PLATE (Item 2-2)
• BOTTOM ASSY (Item 2-3)
• MOTOR HOLDER (Item 2-16)
• PINCH ARM CAP (Item 2-17)
• PINCH UNIT (Item 2-17)
• BRAKE CAM PLATE (Item 2-19)
• LOADING ARM ASSY (SP) (Item 2-30)
• LOADING ARM ASSY (TU) (Item 2-30)
(Removal)
1. Remove the CUT WASHER and WASHER shown in
Fig. 2-31-1. Then, remove the A/L LEVER.
LOADING ARM ASSY (TU)
Apply grease (MULTEMP AC-DM)
to the parts marked by
LOADING ARM
ASSY (TU)
CUT WASHER
WASHER
MAIN PLATE ASSY
- 22 -
.
Fig. 2-30-2
LOADING ARM
Mark
ASSY (SP)
Fig. 2-30-3
A/L LEVER
GREASE (MOLYKOTE G PASTE)
Fig. 2-31-1