Table of Contents
Advertisement
Chapter 2 Preparations
3.
Push the DIMM straight into the socket.
When a DIMM is inserted into the
socket, the lever automatically closes.
4.
Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
5.
Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, see Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
6.
Run BIOS Setup Utility and select Memory Configuration and then Memory Information from the
Advanced menu. Make sure the capacity of added DIMM is displayed properly.
See Chapter 2 (1. System BIOS) in "Maintenance Guide".
7.
Select Memory Configuration from the Advanced menu, and then specify Yes for Memory Retest.
After that, select Save Changes and Exit to reboot.
8.
Set the size of Paging File to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, see Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information)) in
"Installation Guide (Windows)".
For other OS, follow the manual of the OS.
1.13.6 Replacement / Removal
To remove DIMM, reverse the installation procedure.
Be sure to install dummy cover to the slots from where DIMMs are removed.
Take the steps below after replacing or removing DIMMs.
1.
Confirm that no error messages are displayed on POST. If any error message is displayed, see
Chapter 3 (1. Post Error Message) in "Maintenance Guide".
2.
Run BIOS Setup Utility, select Memory Configuration from the Advanced menu, and then
specify Yes for Memory Retest. After that, select Save Changes and Exit to reboot.
3.
Set the size of Paging File to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, see Chapter 1 (7.1 Specifying Memory Dump Settings (Debug
Information)) in "Installation Guide (Windows)".
For other OS, follow the manual of the OS.
Note
Keep the removed dummy cover for future use.
• Make sure the orientation of the DIMM. The DIMM has a notch, preventing
Important
being incorrectly inserted.
• Do not apply too much pressure when you push a DIMM into the socket.
Doing so can damage the socket or terminal part.
Important
Failing to install dummy cover to vacant slot may cause malfunction of the
server due to insufficient cooling effect.
Note
When removing a defective DIMM, check error messages displayed at POST or
NEC ESMPRO and check the DIMM socket where the defective DIMM is installed.
Express5800/R120e-2M User's Guide
1. Installing Internal Optional Devices
Key slot
Key slot
Key
71
Advertisement
Table of Contents
