Placing The Documents On The Adf Paper Chute - Fujitsu Scan Partner 300C Instruction Manual

3.6.2.2

Placing the documents on the ADF paper chute

Perform the following steps to place the document in the ADF paper chute. If these steps are not followed
closely, a feed error may occur.
Figure 3-8 Placing the document on the ADF paper chute
1. Place the document upside-down.
2. Angle the document sheets as shown. (See "Angling the document sheets" that follows for an explanation of
this procedure.)
3. Spread open the right and left guides of the ADF paper chute, and set them approximately 5 mm wider than
the document width.
3-12