Send Diagnostic Command - Fujitsu Scan Partner 300C Instruction Manual

(j) Command-specific information bytes: Bytes 8 to B
On this scanner, this field is not supported and is fixed to X'00000000'.
(k) Additional sense code, additional sense code qualifier: Bytes C and D
A combination of these fields specifies detailed information about the error reported in the sense key. This scanner
reports the following information:
(l) Sense-key specific bytes: Bytes F to 11
This field is reserved on this scanner.
(X'00000000' must not be expected.)

4.4.5 SEND DIAGNOSTIC command

The following table shows the normal sequence of the SEND DIAGNOSTIC command when used with this scanner.
Step
1
2
Sense Additional Additional
key sense code sense code
qualifier
0 O0
2 O0
3 80
3 80
3 80
4 44
4 47
5 20
5 24
5 25
5 26
6 00
B 43
Table 4-14
SEND DIAGNOSTIC command
Bus phase
BUS FREE Verifies bus free
ARBITRATION ON Obtains bus-usage right
Table 4-13
Description
00 No-sense
00 Not ready
0l Jam
02 ADF cover open
03 Document chute empty of paper
00 Abnormal internal target
00 SCSI parity error
00 Invalid command
00 Invalid field in CDB
00 Unsupported logical unit
00 Invalid field in parameter list
00 UNIT ATTENTION
00 Message error
← ← → →
Initiator operation
4-29
Target operation