Removing the G8264 from a Standard Equipment Rack
1.Disconnect all external cables.
2.If the air‐duct option has been installed, remove it as described in "Removing the Air‐Duct Option" on
page
71.
3.Loosen and remove M6 screws, washers, and clip nuts (or cage nuts) to release the switch unit from the
rack.
3
4.Slide the switch unit out of the rack.
5.Loosen and remove the M4 screws attaching the mounting bracket on each side of the switch.
© Copyright Lenovo 2017
This section describes how to remove the G8264 from a standard 19‐inch equipment
rack. For information about removing the switch from other supported racks, see
the appropriate section in this chapter.
To remove the G8264 from a standard rack, complete the following steps:
6
4
1
2
Chapter 4: Removing and Replacing G8264 Components
65