8.Loosen and remove the M4 screws that attach the front mounting brackets to each side of the switch.
9.If replacing the unit with another G8264, see "Replacing the G8264" on page
Removing the G8264 from a Lenovo iDataPlex Rack
1.Disconnect all external cables.
2.If the 1U air‐duct option has been installed, remove it as described in "Removing the Air‐Duct Option"
on page
71.
3.Loosen and remove the M6 washers, screws, and clip nuts that attach the alignment plate.
© Copyright Lenovo 2017
1
This section describes how to remove the G8264 from a Lenovo iDataPlex rack.
To remove the G8264 from an iDataPlex rack, complete the following steps:
5
3
4
Chapter 4: Removing and Replacing G8264 Components
1
6
2
72.
7
69