Toro 03781 Operator's Manual page 17

Figure 13
1. Hose guide (Left hand
shown)
2. Rod bracket
1
1. Hose guides (each must lean toward the center cutting unit)
Note: When installing or removing the cutting
units, make sure the hairpin cotter is installed
in the spring rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
6. Increase the steering on the rear cutting units by
removing the (2) pivot spacers, hex socket screws and
flange lock nuts (Figure 15) from the rear (#2 and #3)
cutting unit carrier frames (Figure 12).
3. Nuts
Figure 14
17
1
g019602