Using The Cutting Unit Kickstand; Greasing The Machine - Toro 03781 Operator's Manual

6
Using the Cutting Unit
Kickstand
Parts needed for this procedure:
1 Cutting unit kickstand
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand to make sure the nuts on the back end of the
bedbar adjusting screws are not resting on the work surface
(Figure 22).
Figure 22
1. Cutting unit kickstand
Secure the kickstand to the chain bracket with the snapper
pin (Figure 23).
1. Chain bracket
2. Snapper pin
7

Greasing the Machine

No Parts Required
Procedure
Before the machine is operated, it must be greased to ensure
proper lubrication. Refer to Lubrication section. Failure to
properly grease the machine will result in premature failure of
critical parts.
20
Figure 23
3. Cutting unit kickstand