Maintenance; Using The Kickstand When Tipping The Cutting Unit; Lubricating The Verticutter - Toro Reelmaster 7000-D Operator's Manual

Maintenance

Using the Kickstand When
Tipping the Cutting Unit
Note:
Whenever the verticutter has to be tipped
to expose the verticutter blades, use the kickstand
(supplied with traction unit)
Figure 15
1. Kickstand
(Figure 15).
g195547

Lubricating the Verticutter

Each verticutter has 5 grease fittings
must be lubricated weekly with No. 2 lithium grease.
The lubrication points are the front roller (2), the rear
roller (2), and the reel motor splines (1).
Important:
Lubricating the cutting units
immediately after washing helps purge water out
of the bearings and increases bearing life.
1. Wipe each grease fitting with a clean rag.
2. Apply grease until you see clean grease coming
out of the roller seals and the bearing relief valve
(Figure 16).
1. Relief valve
3. Wipe any excess grease away.
12
(Figure
Figure 16
16) that
g029271