4
Installing the
Turf-Compensation Spring
Parts needed for this procedure:
1
Turf-compensation assembly
1
Long bolt
2
Carriage bolt
3
Flange locknut
1
Flange nut
Procedure
Install the turf compensation spring assembly on the
same side as the reel motor
1. Long bolt
2. Compensation spring
assembly
3. Carriage bolts
(Figure 4
and
Figure
Figure 7
4. Flange locknuts
5. Flange nut
5
Adjusting the Verticutter
No Parts Required
Procedure
Refer to
Adjusting the Verticutter (page
6
Mounting the Verticutter
Reel
7).
No Parts Required
Procedure
Important:
When lowering the verticutter reels,
care must be taken to prevent damage to the reel
blades due to contact with a concrete floor or a
paved surface. Lower the transport rollers before
lowering the verticutters to a concrete floor or a
paved surface.
Verticutter reels are mounted to the traction unit the
same way reel cutting units are. Refer to the traction
unit Operator's Manual for mounting instructions.
Install the reel motor and grease the side plate until
excess grease oozes out of the relief valve; refer to
g196548
Lubricating the Verticutter (page
8
9).
12).