Toro Reelmaster 7000-D Operator's Manual page 10

Adjusting the Rear Grass Shield
Note:
When operating in turf conditions where there
is excessive debris or thatch, open the rear discharge
shield to help allow the debris to discharge from the
reel.
1. Loosen the bolts on the pivot of the grass shield
(Figure 9).
1. Pivot bolt
2. Rotate the grass shield to the desired setting,
and tighten the bolts
CAUTION
Thrown debris could cause personal injury.
Do not open the rear shield so that it is higher
than level to ground.
Adjusting the Roller Scrapers
1. Loosen the flange nuts that secure the roller
scrapers (Figure
Figure 10
1. Front roller scraper
2. Cotter pin
2. Move the scraper rods in or out to attain 0.0 to
0.75 mm (0.0 to 0.03 inch) clearance between
the scraper and the roller.
3. Ensure that the scraper rod is parallel to the
roller and to the level surface.
Figure 9
2. Rear grass shield
(Figure 9).
10).
3. Transport roller
4. Rear roller scraper
4. Tighten the flange nuts to lock the adjustment.
Adjusting the Transport Rollers
Before the verticutters are lowered to the shop floor
or removed from the traction unit, lower the transport
rollers (Figure 10) to protect the blades from hard
surface contact.
1. Remove the cotter pin that secures the transport
roller bracket to the side plate pin.
2. Position the transport roller as follows:
•
Lower the roller bracket before the verticutter
is lowered to the shop floor.
•
Raise the roller bracket after the verticutter is
raised to the operating position.
3. Secure the transport roller bracket to the side
plate pin with the cotter pin.
4. Repeat the procedure on the opposite end of
the verticutter.
g195550
Adjusting the Cutting-Unit
Steering
Increasing the Steering for the Rear Cutting
Units
Increase the steering on the rear cutting units by
removing the 2 pivot spacers, hex socket screws, and
flange locknuts
of the rear cutting units (cutting units 2 and 3); refer
to Figure 12.
g313796
1. Hex socket screw
2. Pivot spacer
10
(Figure 11) from the carrier frames
Figure 11
3. Carrier frame
4. Flange locknut
g015978