Toro 03781 Operator's Manual page 27

Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 7 operating configuration settings that are adjustable
within the Settings Menu of the InfoCenter: Blade Count,
Mow Speed, Height of Cut (HOC), F Reel RPM and R Reel
RPM. These settings can be locked by using the Protected
Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
Accessing the Protected Menu Settings
To access the Protected Menu Settings
•
From the Main Menu, scroll down to the Settings Menu
and press the right button.
•
In the Settings Menu, scroll down to the Protected Menu
and press the right button.
•
To enter the passcode, use the center button to set the
first digit then press the right button to move on to the
next digit.
•
Use the center button to set the second digit then press
the right button to move on to the next digit.
•
Use the center button to set the third digit then press the
right button to move on to the next digit.
•
Use the center button to set the fourth digit then press
the right button.
•
Press the middle button to enter the code.
•
If the code has been accepted and the protected menu has
been "Unlocked", "PIN" will be displayed in the upper
right corner of the display screen.
The ability to view and change the settings in the Protected
Menu can be changed. Once the Protected Menu has been
accessed, scroll down to Protect Settings. Using the right
button, changing Protect Settings to OFF will allow the
ability to view and change the settings in the Protected Menu
without entering the passcode. Changing Protect Settings to
ON will hide the protected options and will require entering a
passcode to change the setting in the Protected Menu. After
the pass code has been set, the key switch must be turned off
and back on to enable and save this feature.
Note: If the passcode has been forgotten or misplaced,
please contact your distributor for assistance.
To Set the Blade Count
•
In the Settings Menu, scroll down to Blade Count
•
Press the right button to change the blade count between
5, 8 or 11 blade reels.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
To Set the Mow Speed
•
In the Settings Menu, scroll down to Mow Speed.
•
Press the right button to select mow speed.
•
Use the center and right button to select the appropriate
mow speed set on the mechanical mow speed limiter on
the traction pedal.
•
Press the left button to exit mow speed and save the
setting.
To Set the Height of Cut (HOC)
•
In the Settings Menu, scroll down to HOC.
•
Press the right button to select HOC.
•
Use the center and right button to select the appropriate
HOC setting. (If the exact setting is not displayed, select
the nearest HOC setting from the list displayed).
•
Press the left button to exit HOC and save the setting.
To Set the Front and Rear Reel Speeds
Although the front and rear reel speeds are calculated by
inputting the number of blades, mow speed and HOC into
the InfoCenter, the setting can be manually changed to
accommodate for different mowing conditions.
•
To change the Reel Speed Settings, scroll down to the F
Reel RPM, R Reel RPM or both.
•
Press the right button to change the reel speed value. As
the speed setting is changed, the display will continue to
show the calculated reel speed based on blade count,
mow speed and HOC which was previously entered, but
the new value will also be displayed.
27