Spectrum Management; Software Upgrade Complete; Reboot Confirmation Pop Up - Motorola PTP 300 series User Manual

Web Page Reference
Figure 56 Software Upgrade Complete
When the software image has been written to non-volatile memory Figure 56 will be displayed
showing the status of the software upload.
Reboot the unit by clicking the "Reboot Wireless Unit" button. You will be asked to confirm this
Figure 57.
action as shown in
Figure 57 Reboot Confirmation Pop Up
This will reboot the unit, taking up to 120 seconds. During this time you will not be able to
communicate with the unit.
If you cannot communicate with the unit after 120 seconds, this could indicate a problem with the
memory update process. Under these circumstances the user should enter "Recovery Mode", see
Section 9 "Recovery Mode".
After the reboot the user should check that the required software image is loaded and running.
NOTE: Please ensure that you are upgrading the correct units.

8.3.7 Spectrum Management

Spectrum Management Selection is the PTP 300 Series Bridge feature that monitors the available
wireless spectrum and directs both ends of the wireless link to operate on a channel with a minimum
level of co-channel and adjacent channel interference.
8.3.7.1 Wireless Channels
The PTP 300 Series Bridge operates using a set of predefined overlapping channels. There are a
different number of channels, depending on the raster mode selected. Each channel occupies 15
96