Table of Contents
Advertisement
1
4
1. Motor pulley
2. Idler pulley
3. Belt
4. Belt guide
E. If needed, pivot the motor on the motor deck
until the motor pulley and the idler pulley are
aligned to the straightedge
F. Tighten the nuts and bolts that secure the motor
to the motor deck to a torque of 18 N-m (13 ft-lb).
G. Check the air gap between the motor deck and
the roller on the clutch. If the air gap is not within
the specified range, repeat step
measurement is within the specified range.
H. Install the divider plate; refer to
Divider Plate (page
Important: Ensure that the paddles do not rotate when
the clutch lever is in the O
Replacing the Belts
Service Interval: Every 2 years—Replace the belts.
Removing the Belts
1. Move the clutch lever to the O
Controlling the Paddles (page
2. Remove the divider plate; refer to
Divider Plate (page
3. Remove the nut that secures the belt guide to the
motor, and remove the belt guide
3
2
5
6
7
Figure 36
5. Idler shaft
6. Jam nut
7. Setscrew
8. Straightedge
(Figure
36).
3
until the air gap
Installing the
23).
position.
FF
position; refer to
FF
19).
Removing the
22).
(Figure
37).
1
2
1. Nut
4. Slip the forward belt forward and off the idler pulley
(Figure
8
g020663
1
1. Motor pulley
2. Forward belt
5. Slip the rear belt rearward and off the idler pulley
(Figure
6. Slip the belts off the motor pulley.
7. Remove the belts from the machine.
Installing the Belts
1. Ensure that the clutch lever is in the O
refer to
2. Align the rear belt to the rear groove in the motor
pulley.
Note: Do not align the rear belt to the idler pulley.
3. Align the forward belt to the forward groove of the
idler pulley.
26
Figure 37
2. Belt guide
38).
Figure 38
3. Idler pulley
4. Rear belt
38).
Controlling the Paddles (page
G021601
2
3
4
G021608
position;
FF
19).
Advertisement
Table of Contents
