Setting Vertical Angle Of A Airflow; Setting Horizontal Angle Of Airflow - Beko BEVPI 090 User Manual

2 Un t spec f cat ons and features
C
Note:
Illustrat ons n th s manual are for explanatory purposes. The actual shape of your
ndoor un t may be sl ghtly d fferent. The actual shape shall preva l.
Sett ng angle of a r flow
Sett ng vert cal angle of a r flow
Wh le the un t s on, use the SWING/DIRECT button to set the d rect on (vert cal angle) of a rflow.
1. Press the SWING/DIRECT button once to act vate the louver. Each t me you press the button, t
w ll adjust the louver by 6°. Press the button unt l the d rect on you prefer s reached.
2. To make the louver sw ng up and down cont nuously, press and hold the SWING/DIRECT button
for 3 seconds. Press t aga n to stop the automat c funct on.
Sett ng hor zontal angle of a r flow
The hor zontal angle of the a rflow must be set manually. Gr p the deflector rod (See F g.B) and
manually adjust t to your preferred d rect on.
For some un ts, the hor zontal angle of the a rflow can be set by remote control. please refer to the
Remote Control Manual.
Note on louver angles:
When us ng COOL or DRY mode, do not set louver at too vert cal an angle for long
per ods of t me. Th s can cause water to condense on the louver blade, wh ch w ll drop
C
on your floor or furn sh ngs. (See F g.A)
When us ng COOL or HEAT mode, sett ng the louver at too vert cal an angle can reduce
the performance of the un t due to restr cted a r flow.
Do not move louver by hand. Th s w ll cause the louver to become out of sync. If th s
occurs, turn off the un t and unplug t for a few seconds, then restart the un t. Th s w ll
reset the louver.
10 / 64 EN
Spl t-type room a r cond t oner / User Manual