ABB K-MAG 10D1476 Instruction Manual page 15

10D1476 K-MAG MAGNETIC FLOWMETER INSTRUCTION MANUAL
The temperature gradient between the liquid and the ceramic spool should
not exceed 212
o
(70 C) when cooling, to prevent cracking. For example, if the ceramic is at
a temperature of 20
perature is 180
5 minutes at 120
eration should be made when cooling. This is especially important when fol-
* SIP procedures per pharmaceutical industry.
Pressure Rating
Meter
size
1 - 80 mm
⁄
( - 3 in)
1
25
100 mm
(4 in)
Vacuum Limit
Meter Calibration Factor
Physical Characteristics
Outline Dimensions, magnetic
flowmeter with or without
signal converter
1-40 mm (1/25 - 1-1/2")
50 - 100 mm (2 - 4")
Remote Mounted Signal
Converter
Conduit Connections
Meter Weight
Signal Converter Vibration
Limit
NOTE
o o
F (100 C) when increasing the temperature or 158
o
C, liquids at 120
o
C, the ceramic spool should be stabilized for approximately
o
C before allowing it to increase to 180
lowing SIP* (Steam-in-place) procedures.
o o
38 C (100 F)
5.11 MPa
(740 psi)
2.00 MPa
(285 psi)
full vacuum at 180
specified on primary data tag (equal to max flow
capacity in engineering units). This factor is
equivalent to a flow velocity of 33.33 ft/s in the
metering tube.
Standard
See Figure 2-1
See Figure 2-2
See signal converter instruction manual
(2) 1/2" NPT internally threaded entrances in pri-
mary junction box
See signal converter instruction manual
5 to 14 Hz, 0.20";
14 to 200 Hz, 1.5 g
o
C can be handled. If the liquid tem-
o
C. A similar consid-
Temperature
o o
130 C (266 F) 180
4.62 MPa
(699 psi)
1.66 MPa
(240 psi)
o o
C (356
with Sanitary Fittings
See Figure 2-3
See Figure 2-4
o
F
o o
C (356 F)
4.43 MPa
(643 psi)
1.45 MPa
(210 psi)
F)
1-7