Fujitsu 565Tx User Manual page 134

S e c t i o n F i v e
Problem
C A U T I O N
Due to ongoing changes in USB t e c h n o l o g y
and standards, not all USB devices and/or
drivers are guaranteed to work.
PC Card Problems
A card inserted in the PC Card slot does not
work or is locking up the system.
10
Possible Cause
4. You may have the wrong I/O address selected
for your device.
5. Your device and another device are assigned
the same I/O address.
1. The card is not properly installed.
2. The card may have been installed with an
application running and your notebook
doesn't know it is there.
3. Your software may not have the correct
software driver active.
4. You may have the wrong I/O addressselected
for your PC Card device.
5. Your PC Card device and another device are
assigned the same I/O address.
Possible Solution
4. See your device documentation and software
documentation to determine the required
I/O address.
5. Check all I/O addresses in the BIOS Setup
Utility and your other installed hardware
and software and make sure there are
no duplications.
1. Remove and re-install the card.
(See PC Cards on pages 87–89.)
2. Close your application and restart
your notebook.
3. See your software documentation and
activate the correct driver.
4. See your PC Card documentation and soft
ware documentation to determine the
required I/O address.
5. Check all I/O addresses in the BIOS setup
utility and your other installed hardware
and software and make sure there are
no duplications.