Navigating Through The Setup Utility - Fujitsu 565Tx User Manual

S e c t i o n T h r e e
P O I N T
If your data security settings require it,
you may be asked for a password before
the Main Menu will appear.
Entering the Setup Utility After a
Configuration Change or System Failure
If there has been a change in the system config-
uration that does not agree with the parame ter
settings stored in your BIOS memory, or there
is a failure in the system,the system beeps and/
or displays an error message after the Power On
Self Test (POST). If the failure is not too severe,
it will g ive you the opportunity to modify the
settings of the setup utility, as described in the
following steps:
1. When you turn on or restart the computer
there is a beep and/or the following message
appears on the screen:
Error message – please run SETUP
p r o g r a m
Press <F1> key to continue, <F2>
to run SETUP
54
2. If an error message is displayed on the
screen, and you want to continue with the
boot process and start the o perating system
anyway, press the F1 key.
C A U T I O N
If your notebook beeps a series of beeps
that sounds like a code and the display is
blank, please refer to the Tro u b l e s h o o t i n g
Section. (See pages 133–135.) The Tro u b l e -
shooting Section includes a list of e rror
m e s s a g e s and their meanings.
P O I N T
If your data security settings require it,
you may be asked for a password before
the operating system will be opened.
3. If an error message is displayed on the screen,
and you want to enter the setup utility, press
the F2 key.
4. When the setup utility starts with a fault
present,the system displays the following
message:
W a r n i n g !
Error message
[ C o n t i n u e ]
5. Press any key to enter the setup utility. The
system will then display the Main Menu with
current parameters values.
NAVIGATING THROUGH
THE SETUP UTILITY
The BIOS setup utility consists of 5 menus;
MAIN,ADVANCED, SECURITY, POWER
SAVINGS and EXIT. The remainder of Section
Three explains each menu in turn including all
submenus and setting items.
The following procedures allow you to navigate
the setup utility menus:
1. To select a menu, use the cursor keys:
2. To select a field within a menu or a submenu,
use the cursor keys: , .
, .