Fujitsu FI-4860C2 Operator's Manual page 251

22. Setting Interface
1) Press (Next button) or
<Screen22>.
2) At <Screen22>, press
select the type of interface.
The blinking item is the one selected.
HINT
Available interface settings are as follows:
(1) [Auto] is blinking:
(2) [SCSI] is blinking: SCSI interface is used. The interface on TPS is disre-
(3) [TPS] is blinking:
By pressing
By pressing
3) Press (Enter button) to confirm the setting.
Press (Exit button) at the end and the LCD display goes back to [Ready]
screen.
(Previous button) and let LCD display
<Screen22>
! 2 2 I
= A u t
(Left arrow button) or
If an interface board, either from third party or
optional, is installed in TPS, this interface is used. If
not, SCSI interface is used.
garded.
TPS interface is used. The SCSI interface is disre-
garded.
(Left arrow button), selection moves from (3) to (1).
(Right arrow button), selection moves from (1) to (3).
n t e r f a c
o / S C S I /
(Right arrow button), and
7.3 Setup Mode Details
e
T P S
7-51
7